Wpwv250-20-a worm gear reducer has large bearing capacity, stable use, high reliability, high efficiency and stability,.
Reducer overview:
WP worm gear reducer is developed on the basis of WD reducer. The worm is made of 45# steel through heat treatment, and the worm gear is cast with tin bronze. It has good wear resistance, especially in terms of bearing capacity. It is mainly suitable for deceleration transmission of various mechanical equipment such as plastics, metallurgy, beverage, mining, lifting transportation, chemical construction and so on.
The main functions of the reducer are:
1) Reduce the speed and increase the output torque at the same time. The torque output ratio shall be multiplied by the motor output by the reduction ratio, but pay attention not to exceed the rated torque of the reducer.
2) Deceleration also reduces the inertia of the load, which is the square of the reduction ratio. You can see that general motors have an inertia value.
Features of reducer:
1. Stable transmission, low vibration, impact and noise, large reduction ratio, and can be used with various mechanical equipment.
2. It can obtain large transmission ratio with single-stage transmission and compact structure. Most types of reducers have good self-locking, and can save braking devices for mechanical equipment with braking requirements.
3. The meshing friction loss between worm tooth and worm gear tooth surface is large, so the transmission efficiency is lower than that of gear, easy to heat and high temperature.
4. Higher requirements for lubrication and cooling.
5. Good compatibility, worm gears and worms are manufactured according to national standards, and standard parts are used for bearings and oil seals.
Precautions for reducer:
1. Worm gear shaft cannot be used as input shaft.
2. The supporting motor (i.e. power) shall not exceed the value specified on the label.
3. If the user wants to change the direction of entering the shaft, remove the second end cover of the lower shaft, take out the worm shaft and adjust 180. Just load it. Do not knock hard when pressing, but slowly drive the two shafts to make them mesh.
WPWV250-50    WPWV200-50    WPWV175-50    WPWV155-50    WPWV135-50    WPWV120-50
WPWV100-50    WPWV80-50    WPWV70-50    WPWV60-50    WPWV50-50    WPWV40-50
WPWV250-40    WPWV200-40    WPWV175-40    WPWV155-40    WPWV135-40    WPWV120-40
WPWV100-40    WPWV80-40    WPWV70-40    WPWV60-40    WPWV50-40    WPWV40-40