The WPWK80,WPWK100,WPWK120,WPWK135,WPWK155 cycloidal gear reducer is a commonly used reduction device in mechanical transmission. Its working principle is to reduce the output signal of the high-speed motor to the desired speed through the meshing of the cycloidal gear and the internal gear. Before using this type of reducer for transmission, it must be installed correctly. The following will introduce the installation steps and precautions for the cycloidal needle reducer.
How to install the cycloidal needle reducer
1、 Installation steps for cycloidal needle reducer
1. Determine the installation position of the reducer: Before installation, it is necessary to determine the position of the reducer in the entire mechanical transmission system to ensure the accuracy and convenience of the connection.
2. Prepare for installation of foundation: Select suitable foundation and positioning holes for installation according to the specifications and requirements of the reducer.
3. Fixation of gearbox: Use bolts to firmly fix the gearbox on the selected foundation.
4. Connect the gearbox and mechanical shaft: Connect the gearbox output shaft to the input shaft of the transmission device.
5. Motor connection: Connect the gearbox and motor output shaft through a coupling to synchronize the gearbox with the motor output shaft.
6. Calibrate the position of the gearbox: Ensure the alignment and angle between the output shaft and input shaft of the gearbox.
7. Oiler and refueling: While ensuring that the gearbox has sufficient lubricating oil, attention should also be paid to the appropriate amount of oil and the selection of oil products.
2、 Installation precautions for cycloidal reducer
1. Check the foundation and positioning holes: Before installing the reducer foundation, it is necessary to check the appearance quality and whether the position and specifications of the positioning holes meet the requirements.
2. Correct the alignment of the gearbox and mechanical shaft: Due to production and transportation reasons, the gearbox may deviate from the axis during installation, so it is necessary to inspect and correct it before installation.
3. Installation method: To ensure the normal operation of the reducer and reduce noise, appropriate installation methods and techniques should be selected, such as the commonly used foot type and flange type.
4. Quality considerations for lubricating oil: The gearbox should be filled with lubricating oil before use, and high-quality oil should be selected to ensure the normal operation of the equipment.
Through the above steps and precautions, the cycloidal reducer can be installed correctly and operate normally, bringing convenience and reliability to mechanical transmission. I hope this article is helpful to you.
