WPWO100,WPWO120,WPWO135,WPWO155,WPWO175 Precision planetary gear reducer gear accessories processing requires maintenance. First of all, precision planetary gear reducer can only be installed on a flat, shock-absorbing, torsion-resistant support structure. Under no circumstances is it allowed to hammer pulleys, couplings, pinions or sprockets, etc., into the output shaft as this will damage the bearings and shaft. Precision planetary gear reducer is space-saving, reliable and durable, with high overload capacity, power up to 200KW, low energy consumption, superior performance, deceleration efficiency up to 95℅ or more, small vibration, low noise, rigid cast iron box, high-grade gear surface Frequent heat treatment and precision machining form helical gears and bevel gears.
The gear reducer is a special reducer for various reactors. Its gear adopts Gleason quasi-hyperbolic tooth profile. The gear has a hard tooth surface and has the characteristics of large load-bearing capacity, low noise, long life, high efficiency, and smooth operation. The performance of the whole machine is far better than that of cycloidal pinwheel reducer and worm gear reducer, and it has been widely recognized and applied by users. The gear module is a very important knowledge point in the precision planetary gear reducer. The higher the module tooth, the thicker it is. The module refers to the ratio of the tooth pitch t between the tooth profiles on the same side of two adjacent gear teeth and the pi ratio π. (m=t/π) is in millimeters. Module is one of the most basic parameters of modular gear teeth. The larger the modulus.
If the number of gear teeth is constant, the radial size of the wheel will also be larger. The module series standards are formulated based on the requirements of design, manufacturing and inspection. For gears with non-spur teeth, the modules are distinguished by the normal module mn, the end module ms and the axial module mx, both of which are based on their respective teeth. The ratio of pitch (normal pitch, end pitch and axial pitch) to pi is also expressed in millimeters. For the bevel gear module, there are big end module me, average module mm and small end module m1. For tools, there are corresponding tool modules mo, etc. The standard module is widely used.
