Cycloid pin gear wpx80 reducer is a novel transmission device which applies the principle of planetary transmission and adopts cycloid pin tooth meshing. All transmission devices of cycloid needle wheel wpx80 reducer can be divided into three parts: input part, deceleration part and output part.
The input shaft is equipped with a double eccentric sleeve with an offset of 180 °, and the eccentric sleeve is equipped with two roller bearings called the rotating arm to form the H mechanism. The center holes of the two cycloid wheels are the raceway of the rotating arm bearing on the eccentric sleeve, and the cycloid wheel is meshed with a group of annular needle teeth on the needle gear to form an internal meshing reduction mechanism with a tooth difference of one tooth, (in order to reduce friction, in the reducer with small speed ratio, the needle tooth is equipped with a needle tooth sleeve).
Cycloid pin gear wpx80 reducer adopts cycloid pin gear meshing and planetary transmission principle, so it is usually called planetary cycloid wpx80 reducer. Planetary cycloid pin gear wpx80 reducer can be widely used in petroleum, environmental protection, chemical industry, cement, transportation, textile, pharmaceutical, food, printing brush, hoisting, mining, metallurgy, construction, power generation and other industries as driving or deceleration devices. Its unique stable structure can replace the ordinary cylindrical gear wpx80 reducer and worm gear reducer in many cases. Therefore, the planetary cycloid pin gear reducer is widely used in various industries and fields and is generally welcomed by the majority of users.
1. The cycloid needle wheel wpx80 reducer is allowed to be used in the continuous working system, and it is allowed to operate in both positive and negative directions.
2. The rated speed of the input shaft is 1500 rpm. When the input power is greater than 18.5 kW, it is recommended to use a 6-pole motor with 960 rpm.
3. The working positions of horizontal installation cycloidal needle wheel wpx80 reducer are horizontal. During installation, the maximum horizontal inclination angle is generally less than 15 °. When it exceeds 15 °, other measures shall be taken to ensure sufficient lubrication and prevent oil leakage.
4. The output shaft of cycloid pin gear wpx80 reducer cannot be subjected to large axial force and radial force. When there is large axial force and radial force, other measures must be taken.