characteristic:
1. Low return clearance, high output torque
2. Reduction ratio i = 3 ~ 4096 Jin degree < 5 < > arc minute, low noise, high quality, arbitrary installation position, simple motor installation and lifelong lubrication
3. In order to lift the worm gear reducer, non-ferrous metal is generally used as the worm gear and hard steel is used as the worm,
4. Because it is a sliding friction transmission, it will generate high heat during operation, resulting in differences in thermal expansion between various parts and seals of the reducer, resulting in gaps on various mating surfaces, and the oil becomes thinner due to the increase of temperature, which is easy to cause leakage. There are four main reasons: first, whether the material matching is reasonable; second, the surface quality of the meshing and friction surface; third, whether the selection and addition amount of lubricating oil are correct; fourth, the assembly quality and use environment.
Main functions:
1. Reduce the speed and increase the output torque at the same time. The torque output ratio shall be multiplied by the motor output by the reduction ratio, but pay attention not to exceed the rated torque of the reducer.
2. Deceleration also reduces the inertia of the load, which is the square of the reduction ratio. You can see that general motors have an inertia value.
Installation method:
Correct installation is an important link to ensure the normal operation of mechanical equipment in the process of using and maintaining the reducer. Therefore, when you install the reducer, be sure to carefully assemble and use it in strict accordance with the following installation matters.
1. Before installation, confirm whether the motor and reducer are intact, and strictly check whether the dimensions of each part connected between the motor and reducer match. Here are the dimensions and matching tolerances of the positioning boss, input shaft and reducer groove of the motor.
2. Unscrew the screw on the dust hole outside the reducer flange, adjust the clamping ring to align its side hole with the dust hole, insert the hexagon socket and tighten it. Then, remove the motor shaft key.
3. Connect the motor and reducer naturally. During connection, it must be ensured that the concentricity of the reducer output shaft and the motor input shaft is consistent, and the outer flanges of the two are parallel. If the concentricity is inconsistent, the motor shaft will be broken or the reducer gear will be worn.
Conventional reduction ratios are 1:10 / 1:15 / 1:20 / 1:25 / 1:30 / 1:40 / 1:50 / 1:60
About material: worm gear reducer: 200# cast iron box, 45# steel worm, 94 copper worm gear, KS oil seal, cost bearing and other materials made by Jin. At the same time, all derivative models of WP series are sold, which can be designed and manufactured for users.
Conventional transmission ratio: 1 / 10. 1 / 15. 1 / 20. 1 / 25. 1 / 30. 1 / 40. 1 / 50. 1 / 60. Customizable 1 / 5. 1 / 7. 1 / 70. 1 / 80. 1 / 100
