The specific application method of planetary gear reducers is reflected in the usage method. Therefore, they are usually called planetary reducers, and spiral elevators use planetary needle teeth meshing and planetary transmission. WPWV80,WPWV100,WPWV120,WPWV135,WPWV155 Planetary reducers can be widely used in industries such as petroleum power generation as driving or deceleration equipment. Its common bumpy structure can replace ordinary cylindrical gear reducers and worm gear reducers in many situations. Therefore, planetary gear reducers are widely used in various industries and categories, and are widely welcomed by a wide range of users.
The operating conditions of the Newell planetary gear reducer are: allowing both forward and reverse directions to operate simultaneously. Planetary gear reducers are allowed to be used in locations with extended mission systems. When the output power is greater than, it is recommended to use a pole motor for matching. The additional revolutions per minute of the output shaft speed. The task status of horizontal planetary gear reducers is degree level. When equipped, other measures should be taken to ensure smoothness and prevent oil leakage when the maximum inclination angle is less than normal. Other measures must be taken when there are significant axial and radial forces. The input shaft of the planetary gear reducer cannot withstand significant axial and radial forces.
The newly recovered gearbox from the planetary gear reducer factory has been lubricated with smooth grease. Equipment: Due to the fact that the input shaft structure of the reducer cannot accept axial hammering force, indirect hammering methods are not allowed when coupling, pulley, sprocket, and other joint components are added to the input shaft of the planetary reducer. The screw can be screwed into the joint using the shaft end screw hole. The diameter of the input and output shafts should be selected and matched. The lifting eye screws on the gearbox are only for lifting the gearbox. The centerline elevation of the gear reducer should be calibrated when the gear reducer is installed. Degree and its related dimensions of the connected parts. The concentricity of the alignment axis should not exceed the allowable range of the coupling. Steel or cast iron pads can be used to stop and calibrate the gearbox on time. The height of the cushion block should not exceed three, and it can also be stopped with a wedge iron. However, after calibrating the gearbox, a flat cushion block should be replaced.
The oil level should be maintained in the middle of the sight glass, and the horizontal planetary reducer should use a smooth oil pool under normal conditions. When the task conditions are harsh and the ambient temperature is low, cyclic smoothing can be used. In order to improve the function of the reducer and extend the service life of the planetary gear reducer, the extreme pressure Gear oil is normally used for the planetary gear reducer at normal temperature, and the smooth oil should also be reconsidered when working under the condition of upper and lower temperature. To prevent damage to the components of the gearbox, it is necessary to strictly prevent the oil pump from cutting off when equipped with planetary gear reducers. The dirty oil can be discharged. Oil can be added by rotating the ventilation cap on the upper part of the engine seat. When draining oil, unscrew the drain plug at the bottom of the engine seat. And clean the external dirty oil. The current refueling operation should be renewed with a new oil. If the task conditions are harsh, the oil change time can be appropriately extended. Theory suggests that frequent cleaning and oil change of the gearbox play an important role in extending the service life of the gearbox. Smooth oil should be frequently replenished during the application process. Change every six months. The grease is Aluminium sulfide lithium base smooth grease. The above reducers are shipped without smooth oil on the outside.
