The reduction motor is an indispensable spare part of industrial machinery. It is suitable for synchronous belt transmission during operation. However, after working for a long time, the reduction motor will also heat up. I believe everyone has seen this. Question. Based on years of experience, the following reasons can be analyzed: inappropriate motor, too strong packing gland, too tight mechanical seal spring, poor quality of pump components, or poor connection effect, bad wheels and shafts. So what should we do?
First, when the motor overheats, even if the equipment stops running. If we find that the reduction motor is overheated when using the equipment, we should stop running the equipment and even avoid minor problems that lead to major equipment failures.
Secondly, check the relevant parts of the synchronous pulley. Through understanding, we can know that the pulley motor will overheat. The main reasons are that the middle ratio is larger than the motor, the packaging pressure is too large, the assembly quality of the pump is poor, and the connection between the wheel and the shaft is poor. Four. When this phenomenon occurs in the motor, the four parts should be checked in time to find out the cause of the problem.
Finally, different solutions are proposed for the overheating phenomenon caused by different reasons, such as the proportion of medium is greater than that of motor. This problem can be solved by replacing the applicable motor. Therefore, after determining the cause of the problem, we need to adopt corresponding methods to solve the problem. Through the above process, the overheating problem of the reduction motor is better solved.
When heating occurs in the synchronous belt pulley, it can be adjusted according to the above method, so that the work efficiency can be well completed, and only in this way can the enterprise develop. Therefore, industrial belt manufacturers should provide good service for customers with synchronous belts.
WPDA147,WPDA155,WPDA175,WPDA200,WPDA250
